|
[Sponsors] |
[Other] [OpenFOAM] Non-conforming mesh and GGI |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 26, 2012, 02:25 |
[OpenFOAM] Non-conforming mesh and GGI
|
#1 |
Member
M
Join Date: Jul 2012
Posts: 33
Rep Power: 13 |
Hello,
Can we define a non-conformal mesh in OpenFOAM ? I have two fluids, and i want to calcul a heat transfer between these two fluides. But i want to mesh one of them in hexa, and the other in treta, without common nodes. Can I use General Grid interface algorithm ? Excuse for my english. Thank you for any hint, Best regards m_f. Last edited by m_f; July 26, 2012 at 03:01. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Create a GeometricField of a given type on given patch? | philippose | OpenFOAM Programming & Development | 4 | August 12, 2013 12:41 |
[snappyHexMesh] SNappyHexMEsh and GGI (standing mesh gets deleted) | A.Wendy | OpenFOAM Meshing & Mesh Conversion | 1 | August 2, 2013 07:04 |
GGI for volumes / mesh mapping? | orca.blu | OpenFOAM Programming & Development | 2 | September 28, 2012 10:02 |
GGI in OpenFOAM-1.5-dev | philippose | OpenFOAM Running, Solving & CFD | 14 | November 13, 2011 14:55 |