|
[Sponsors] |
September 24, 2012, 14:18 |
Problem in sHM
|
#1 |
New Member
Vincenzo Santoro
Join Date: Apr 2012
Location: Politecnico di Torino
Posts: 16
Rep Power: 14 |
Hi Foamers,
I'm working on a bent tube and I've reached the 100% layer distribution but I have some problem in several parts of model. I may to use a snapEdge to refine boundary but the result is very warped. When I try to run a simulation with illegal mesh, I can't to reach the right tolerance that i want (10^5). I posted fvSchemes fvSolution files too, maybe somebody know how to do. give me a help!! Regards, vincenzo |
|
October 23, 2012, 10:47 |
|
#2 |
New Member
Vincenzo Santoro
Join Date: Apr 2012
Location: Politecnico di Torino
Posts: 16
Rep Power: 14 |
nobody could help me?
vincenzo |
|
October 23, 2012, 15:42 |
|
#3 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128 |
Greetings Vincenzo,
From your description, it's very complicated to help you without additional information. Therefore, here are few questions:
Bruno
__________________
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Problem with SnappyHexMesh | Joehin | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2017 11:21 |
Heat Transfert, mixing problem | Wazdq | CFX | 8 | November 7, 2016 05:44 |
[snappyHexMesh] SHM add layers problem | doubtsincfd | OpenFOAM Meshing & Mesh Conversion | 0 | June 6, 2011 12:01 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |