[Other] Is it possible to convert 6Sigma file to OpenFoam

Gebin Edwin George · April 5, 2018, 00:07

Hi,

I am a Master's student, working on my Thesis, I have been using Fluent for the past two years, and have pretty much good knowledge on how to use the software.

Now I have started using OpenFoam, in regards to my Thesis work. Since the geometry(Data Center) Creation is quite complicated, I decided to use an already created geometry using Six Sigma tool. But now I want to Convert my Six Sigma file to OpenFOAM for simulation. And I couldn't find any way to convert this file. At least if there is a way to convert the 6Sigma file to ANSYS Fluent file, this suggestion is also very much welcomed.

I hope somebody could help me with this problem, And I pretty badly need to do my simulations at the earliest.

Thanks in advance,
Gebin

akidess · April 5, 2018, 03:44

As far as I know 6sigma files are not compatible with any other tool, and Future Facilities do not provide any converters.

Gebin Edwin George · April 5, 2018, 05:26

Thank You!

April 5, 2018, 00:07	Is it possible to convert 6Sigma file to OpenFoam	#1
Gebin Edwin George New Member Gebin Edwin George Join Date: Oct 2016 Posts: 3 Rep Power: 9	Hi, I am a Master's student, working on my Thesis, I have been using Fluent for the past two years, and have pretty much good knowledge on how to use the software. Now I have started using OpenFoam, in regards to my Thesis work. Since the geometry(Data Center) Creation is quite complicated, I decided to use an already created geometry using Six Sigma tool. But now I want to Convert my Six Sigma file to OpenFOAM for simulation. And I couldn't find any way to convert this file. At least if there is a way to convert the 6Sigma file to ANSYS Fluent file, this suggestion is also very much welcomed. I hope somebody could help me with this problem, And I pretty badly need to do my simulations at the earliest. Thanks in advance, Gebin

April 5, 2018, 03:44		#2
akidess Senior Member Anton Kidess Join Date: May 2009 Location: Germany Posts: 1,377 Rep Power: 29	As far as I know 6sigma files are not compatible with any other tool, and Future Facilities do not provide any converters. __________________ On twitter @akidTwit Spend as much time formulating your questions as you expect people to spend on their answer.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFoam "Permission denied" and "command not found" problems.	iyidaniel@yahoo.co.uk	OpenFOAM Running, Solving & CFD	11	January 2, 2018 06:47
[Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0	Seroga	OpenFOAM Community Contributions	9	June 12, 2015 17:18
[swak4Foam] Error bulding swak4Foam	sfigato	OpenFOAM Community Contributions	18	August 22, 2013 12:41
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 11:46
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 01:24

April 5, 2018, 05:26		#3
Gebin Edwin George New Member Gebin Edwin George Join Date: Oct 2016 Posts: 3 Rep Power: 9	Thank You!