|June 5, 2009, 07:28||
PLOT3D to FOAM Boundary Definiton
Join Date: May 2009
Posts: 88Rep Power: 9
I have the following problem: I have a mesh written in PLOT3D file format. I successfully converted this file into an OpenFOAM mesh by using the utility 'plot3dToFoam'.
However, all sides of the domain were summarized to one boundary of type 'wall', called 'defaultFaces'.
Thus, my questions is: how can I define the sides of the domain individually? I'd like to have one inlet and one outlet. Is that possible after I have converted the mesh to OpenFOAM?
Thanks for reading this thread!
grid generation: ICEM CFD 13.0
solver: CFX 13.0
|Thread||Thread Starter||Forum||Replies||Last Post|
|Implementation of boundary conditions for FVM||Tom||Main CFD Forum||7||August 26, 2014 05:58|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|MPI PROBLEMS||gtg627e||OpenFOAM Running, Solving & CFD||20||October 5, 2007 04:02|
|Axisymmetrical mesh||Rasmus Gjesing (Gjesing)||OpenFOAM Native Meshers: blockMesh||10||April 2, 2007 14:00|
|Boundary conditions?||Tom||Main CFD Forum||0||November 5, 2002 02:54|