|
[Sponsors] |
October 14, 2008, 05:02 |
Problems with exporting jpgs
|
#1 |
New Member
Gernot Lukesch
Join Date: Mar 2009
Location: Leoben, Austria
Posts: 11
Rep Power: 17 |
Hello,
I am calculating a furnace where gas is blowen into liquid metal. My problem is that when i creat the jpgs, the colors on the topsurface of the metalbath are very dark also it looks good in paraview. I tried make some changes in the light settings but did not succeed. Also i have activated `Headlight´ it looks like the light comes from the wrong side but when i deactivate it its worse. Any idea ? Is it possible to attache pictures in this forum ? I wanted to do so that u can see the difference between paraview, the written jpgs and my light settings. thank you Gernot |
|
October 28, 2008, 04:46 |
O.k i just have installed para
|
#2 |
New Member
Gernot Lukesch
Join Date: Mar 2009
Location: Leoben, Austria
Posts: 11
Rep Power: 17 |
O.k i just have installed paraview 3.4 and no problem there.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Benchmark Problems to test a new scheme for Convection-diffusion equation | alibaig1991 | Main CFD Forum | 1 | June 16, 2018 04:30 |
Needed Benchmark Problems for FSI | Mechstud | Main CFD Forum | 4 | July 26, 2011 12:13 |
[ICEM] [FLUENT] 2D Geometry problem when exporting to Fluent - Unwanted walls | MikeTichondrius | ANSYS Meshing & Geometry | 1 | February 9, 2011 13:31 |
Two-phase air water flow problems by activating Wall Lubrication Force | challenger85 | CFX | 5 | November 5, 2009 05:44 |
Some problems with Star CD | Micha | Siemens | 0 | August 6, 2003 13:55 |