|
[Sponsors] |
select a point through specifying the coordinates |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 4, 2013, 10:26 |
select a point through specifying the coordinates
|
#1 |
Senior Member
Join Date: Nov 2012
Posts: 171
Rep Power: 13 |
Hi All,
I know I should post this in the Paraview's forum, but I think more friends are here. When I use the filter "plot selection over time", I need to specify a point in the flow fields. In the past I always use the mouse to click on the contour plane. However, this is not very accurate. I would like to select a point through specifying the coordinates. I check the user guide but I did not find a good way to do so. Does anybody know how to do it? Thank you in advance! best regards, H |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
probing vorticity at a point | suryawanshi_nitin | OpenFOAM | 7 | May 15, 2014 05:46 |
[ANSYS Meshing] Importing Cylinders by Point Data Input with Radii | EphemeralMemory | ANSYS Meshing & Geometry | 2 | May 31, 2012 13:34 |
Is it possible to get value of a variable at given coordinates without a point? | technocrat | CFX | 5 | March 23, 2010 17:05 |
CFX Post: Problems with moving point cloud for changing time steps | spatialtime | CFX | 0 | December 7, 2009 04:56 |
[OpenFOAM] Cell Data to Point Data Issues | mcintoshjamie | ParaView | 2 | November 19, 2009 03:55 |