|May 30, 2014, 17:33||
Join Date: May 2014
Posts: 6Rep Power: 4
I am trying to plot dimensionless temperature vs a height ratio at the center of my 2D mesh. I want both the height ratio and dimensionless temperature to be between 0 and 1. To do this I need to define a term, theta, which is calculated from temperature.
theta=(T - Tmin) / (Tmax - Tmin)
where T has been solved for, and Tmin and Tmax are constants.
I'm thinking I should use foamCalc for this but am unsure. If anyone can help that would be great!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Writing/output of simple data into an ASCII-File||matthi||OpenFOAM Programming & Development||22||May 4, 2016 10:42|
|saving data in paraview||aylalisa||OpenFOAM Paraview & paraFoam||3||May 31, 2014 11:38|
|IFStream read float point data problem||liu||OpenFOAM Running, Solving & CFD||0||October 24, 2008 12:14|
|How to update polyPatchbs localPoints||liu||OpenFOAM Running, Solving & CFD||6||December 30, 2005 18:27|
|CFXSolver Error Message using Profile Data on B||Tobias||CFX||0||August 26, 2005 07:27|