|August 26, 2005, 07:27||
CFXSolver Error Message using Profile Data on B
Hello , my name is tobias and I recieve following error message by the CFX solver:
An error has occurred in cfx5solve: The CFX-5 solver was interrupted by signal SEGV (11) No results file has been created.
I simulate the flow out of a helicopter rear fan as 2D simulation (free jet problem). At the inlet boundaries I use previuos calcuteted data profiles for total temperature an for velocity. I stored the data profiles in a Profile Data file (this file is located in the current working directory). There was no problem for CFXPre to initialise the Profile Data File . I guess CFXSolver has a problem in locating the data profiles, because no error message occurs if I run the same simulation without using Profil Data for the inlet regions.
I work with a linux computer (32 bit).
Perhaps somebody is able to help me with this problem, thanks tobias.
|Thread||Thread Starter||Forum||Replies||Last Post|
|who can give me profile data about nasa 37 or 67??||hitleo||Main CFD Forum||2||June 1, 2011 09:34|
|Writing profile data at transient heat transfer analysis||Ama||FLUENT||0||July 5, 2009 07:35|
|applying profile data as a boundary condition||vadivel||CFX||1||June 9, 2007 07:11|
|Profile data , how does it work?||Omer||CFX||0||December 9, 2006 12:02|
|How to update polyPatchbs localPoints||liu||OpenFOAM Running, Solving & CFD||6||December 30, 2005 18:27|