|
[Sponsors] |
October 29, 2012, 11:03 |
Group/Merge boundary faces
|
#1 |
New Member
Join Date: Oct 2012
Posts: 9
Rep Power: 13 |
I have imported a very large model of about 2mio cells and 1k boundary faces.
Most of the boundary faces have the same boundary condition, so I am looking for a method to group or merge some boundary faces. So that I don't have to write down the boundary condition for each of the 1k boundary faces. Is there a command to group or to merge boundary faces? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
[Other] Mesh Importing Problem | cuteapathy | ANSYS Meshing & Geometry | 2 | June 24, 2017 05:29 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Boundary conditions on internal faces | CaroVandame | OpenFOAM | 0 | August 2, 2010 13:56 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |