|
[Sponsors] |
September 19, 2013, 21:43 |
Set boundary condition
|
#1 |
New Member
Haotian
Join Date: Sep 2013
Posts: 5
Rep Power: 12 |
Hi, all
Recently I'm using solidDisplacement to run a case. I get a question here. I'm wondering how to set the displacement boundary on a patch where ux=uy=0, but uz will be calculated during the simulation and not specified? Thank you! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to set boundary condition in supersonic airflow | sailor | FLUENT | 0 | December 14, 2011 01:44 |
External Radiation Boundary Condition for Grid Interface | CFD XUE | FLUENT | 0 | July 9, 2010 02:53 |
External Radiation Boundary Condition (Two sided wall), Grid Interface | CFD XUE | FLUENT | 0 | July 8, 2010 06:49 |
how to set up a wall boundary condition according to calculated wall shear stress? | gameoverli | OpenFOAM Pre-Processing | 1 | May 21, 2009 08:28 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |