|October 18, 2013, 10:00||
Change boundary type at certain level of pressure reached inside domain
Join Date: May 2009
Posts: 46Rep Power: 8
I would like to simulate the fluid passing through a mechanical fuse, I need to break (open the membrane) between two domains at specific pressure (membrane broke).
It is possible with OF?
it is possible with swak4foam?
|October 20, 2013, 02:17||
Join Date: Sep 2009
Location: Tehran, Iran
Blog Entries: 1Rep Power: 15
1- its possible with OpenFOAM (code stream)
2- its possible with swak4Foam (groovyBC in this third party is preferred)
|Thread||Thread Starter||Forum||Replies||Last Post|
|Difficulty in calculating angular velocity of Savonius turbine simulation||alfaruk||CFX||8||December 3, 2013 17:51|
|An error has occurred in cfx5solve:||volo87||CFX||5||June 14, 2013 17:44|
|T Junction Stability||ignacio||OpenFOAM Running, Solving & CFD||5||May 2, 2013 10:44|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|