|November 29, 2013, 01:13||
Boundary condition on imported solid.
Join Date: Jun 2011
Posts: 4Rep Power: 5
Could someone help me with the following question.
I'd like to consider flow domain as shown in attachment: This is a 3D case, where inside a box (represented on a drawing by a large rectangle) there is a cylinder (represented on a drawing by small rectangle). This cylinder is generated using blender and saved for example as stl file. Geometry would be meshed using snappyHexMesh.
The question is:
Is it possible to define a boundary condition (velocity inlet) on a face of imported stl solid?
|November 30, 2013, 08:04||
Join Date: Sep 2009
Location: Tehran, Iran
Blog Entries: 1Rep Power: 14
you can define a patch for stl file, so you can assign what BC you like
|Thread||Thread Starter||Forum||Replies||Last Post|
|Regarding Boundary Condition at Outlet for gas-solid simulation||shubham208011||FLUENT||0||July 11, 2013 16:21|
|Low Mixing time Problem||Mavier||CFX||5||April 29, 2013 01:00|
|No-slip condition for non-resolved boundary layer in open channel banks||AlbertoVe||Main CFD Forum||1||January 17, 2013 04:11|
|How To Convert Fluid wall in Solid Wall Boundary Condition||RGN||FLUENT||4||March 31, 2009 05:43|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|