|
[Sponsors] |
Interpolating velocity to an interface in icoFoam (PISO) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 22, 2013, 12:51 |
Interpolating velocity to an interface in icoFoam (PISO)
|
#1 |
New Member
Join Date: Oct 2013
Posts: 19
Rep Power: 12 |
Hi,
I would like to add some steps to the icoFoam solver. I want to interpolate velocity to the interface (black nodes in the picture below). The interface is going to represent a boundary by adding an extra force term to the navier stokes equation. Does anybody know how i can create such an interface and then interpolate the velocity at the mentioned points? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
velocity streamlines cut at the interface! | Tarantino | FLUENT | 0 | April 11, 2013 05:27 |
convergence in PISO loop of icoFoam | hawkeye321 | OpenFOAM | 0 | December 3, 2012 21:37 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |