 |
 |
 |
|
|
|
[Sponsors] | ||||
April 11, 2013, 06:27
|
velocity streamlines cut at the interface!
|
#1 |
|
Member
Tarantino
Join Date: Feb 2013
Posts: 46
Rep Power: 13  |
Hello!
I am working with the geometry with two-zone, so I define the interface boundary. the the properties of two zone are exactly the same. But after the solution I plot the velocity streamline on a plane going throw two zone. As you can see in the attached figure, in the interface boundary, the streamlines are cut! what this happen and how can I avoid it?  |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFX does not continue | Shafiul | CFX | 10 | February 17, 2011 08:57 |
| How can I cut the velocity profile on the Airfoil? | FFF | Tecplot | 0 | June 5, 2008 19:13 |
| CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 08:22 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 10:11 |
Linear Mode
