|October 22, 2013, 12:51||
Interpolating velocity to an interface in icoFoam (PISO)
Join Date: Oct 2013
Posts: 19Rep Power: 4
I would like to add some steps to the icoFoam solver.
I want to interpolate velocity to the interface (black nodes in the picture below).
The interface is going to represent a boundary by adding an extra force term to the navier stokes equation.
Does anybody know how i can create such an interface and then interpolate the velocity at the mentioned points?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Question about heat transfer coefficient setting for CFX||Anna Tian||CFX||1||June 16, 2013 06:28|
|velocity streamlines cut at the interface!||Tarantino||FLUENT||0||April 11, 2013 05:27|
|convergence in PISO loop of icoFoam||hawkeye321||OpenFOAM||0||December 3, 2012 22:37|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|
|Replace periodic by inlet-outlet pair||lego||CFX||3||November 5, 2002 21:09|