|August 1, 2012, 23:00||
thermal stratification and interface pahse-change
Join Date: Aug 2011
Posts: 45Rep Power: 5
I want to model a thermal stratification in a closed water tank.
Half of the tank filled with water the other half is saturated steam.
The steam pumped through a pipe into the water that is a kind of heat source.
There is interface mass transfer due to the condensation and evaporation between the steam above and water below.
I want resolve the thermal stratification inside the water and pressure variations in the steam part.
Could you suggest me that which OpenFoam solver is suitable for that kind of modeling.
thank you in advance
|October 10, 2012, 16:51||
Join Date: Sep 2012
Location: Azusa, Ca
Posts: 11Rep Power: 4
I am working on a simulation project, though I am trying to model a heat pipe which involves using a liquid (water) in two different phases. Have you had any luck with your model? If so, any tips?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Cannot get similiar result with fluent||qsx4881||CFX||23||November 14, 2011 06:25|