|November 8, 2012, 09:41||
k omega values
Join Date: Apr 2010
Blog Entries: 1Rep Power: 6
I am running rhoSimplecFoam with turb model kOmegaSST for internal flow with moderate total pressure at inlet, so no choking should occur.
So, if I set k and omega at time 0 to values I calculated (on the order of magnitude of a hundred) my simulation crashes after two time steps with FPE.
If I set them to huge values, order of magnitude 1 million , it runs for about 100 time steps and then crashes.
Can anyone explain to me why this is happening?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Numerical errors in nested domain with pre-calculated boundary values||Arnoldinho||OpenFOAM Running, Solving & CFD||3||April 4, 2012 10:31|
|max node values exceed max element values in contour plot||jason_t||FLUENT||0||August 19, 2009 11:32|
|exact face values||RubenG||Main CFD Forum||0||June 22, 2009 11:09|
|strange node values @ solid/fluid interface - help||JB||FLUENT||2||November 1, 2008 13:04|
|Values of k and omega at the wall||oldah||FLUENT||2||February 22, 2008 03:08|