|
[Sponsors] |
Read boundary conditions from previously computed time steps or from file? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 14, 2013, 03:57 |
Read boundary conditions from previously computed time steps or from file?
|
#1 |
New Member
Join Date: Oct 2012
Posts: 17
Rep Power: 13 |
Hi everyone,
I am using a modified version of pimpleDymFoam in OF-1.6-ext. To explain the problem briefly, as an example, from 0 to 2 seconds, I wait for the flow condition to reach its steady state, later, for the next 10 seconds (from 2 - 12) I want to make sure that the program reads the boundary conditions at the inlet for the velocity and some other parameters from the folder created at the end of 2nd sec time step, where I assume that it has reached its steady state. How can I define my boundary conditions at the inlet to be read from a file or a folder which is previously computed? Thanks again in advance for your valuable comments and replies Best |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 04:13 |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
[swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
friction forces icoFoam | ofslcm | OpenFOAM | 3 | April 7, 2012 10:57 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |