|
[Sponsors] |
cyclic boundary with same geometric size but different number of faces? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 17, 2012, 21:53 |
cyclic boundary with same geometric size but different number of faces?
|
#1 |
New Member
Tom Li
Join Date: Aug 2011
Posts: 16
Rep Power: 14 |
Hi
I am just wondering if this is possible. I have a 3D rectangular domain. It is meshed in ICEM with unstructured grid, save to fluent .msh and converted in openfoam using fluent3DMeshToFoam. But when I try to run it, it says the number of faces does not match on the two patches that I set as cyclic. Is there a way to work this out without remeshing the faces with a structured grid? If not, does my way of generating and exporting mesh works when I put a structured surface mesh on both sides? Thanks in advance Cheers, Tom |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with parallel run | Hisham | OpenFOAM Running, Solving & CFD | 9 | March 13, 2012 08:31 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |