|December 2, 2014, 07:47||
how to use dsmcFoam
Join Date: Jul 2013
Posts: 13Rep Power: 3
I am not familiar with Direct Simulation Monte Carlo (DSMC).
At this time, I'd like to simulate the flows around a circular cylinder or a sphere in reentry flight (~ Mach 10 to 20 Hypersonic).
Even though there exit tutorials about it in OpenFOAM itself, those not enough for me to learn how to exactly set up files related to DSMC.
It will be very helpful for me if somebody has experiences and can release example test cases, especially, a circular cylinder and a sphere (all the files to set up each case) for me.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[OpenFOAM] - Coupling dsmcFoam and laplacianFoam||costrom||OpenFOAM||0||October 26, 2014 16:15|
|ForceCoefficients/MachNumber for dsmcFoam||CFDnewbie147||OpenFOAM Running, Solving & CFD||0||April 10, 2014 10:18|
|dsmcFoam unanswered questions...||CFDnewbie147||OpenFOAM||0||February 11, 2014 02:23|
|dsmcFoam setup||hherbol||OpenFOAM Pre-Processing||0||July 14, 2013 17:16|
|how can I Run axisymmetric flow using dsmcFoam ?||mechy||OpenFOAM||4||September 19, 2011 10:25|