|May 29, 2015, 04:54||
fixed waterlevel boundary
Join Date: May 2015
Posts: 4Rep Power: 3
I´m try to simulate a 3D modell, where I have a house with a cellar. Around the house I have a waterlevel which should be fixed (setFields, thats I know).
My problem now is, that with the begin of the simulation the water should flood the house (no problem till this point). But now the waterlevel should stay constant, even if the water fill the house ( no inflow boundary, because the value change during the simulation .
So my question is, how do I have to set the boundarys for this simulation?
Whats the right commands?
Thanks for help.
|May 30, 2015, 03:02||
Join Date: Jul 2013
Posts: 1Rep Power: 0
Which solver are you using? Maybe interFoam?
Matej Muller describes one possible way you could try.
how to set up Hydrostatic pressure distribution in interFoam?
However I wasn't able to get a stable simulation.
Another discussion on this topic can be found here:
Spillway Analysis Fixed Water Surface Boundary Condition
Maybe you have better luck and can share your experience
|boundary fixed waterlevel|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|Overflow Error in Multiphase Modelling with Two Continuous Fluids||ashtonJ||CFX||6||August 11, 2014 14:32|
|Error finding variable "THERMX"||sunilpatil||CFX||8||April 26, 2013 07:00|
|domain imbalance for enrgy equation||happy||CFX||14||September 6, 2012 01:54|
|CFX13 Post Periodic interface||EtaEta||CFX||7||December 8, 2011 18:15|