|December 14, 2009, 02:55||
wedge BC in OpenFOAM
Join Date: Mar 2009
Posts: 38Rep Power: 7
I have a doubt about the BC "wedge". I have axi-symmetric geometry (cylindrical plate) but fluid (drop of oil) is NOT at the centre (0,0,0). Can I apply wedge BC to the geometry? Like, I have meshed 60 degree secor of plate and defined 2 side faces as wedge. Will that be OK or do I need to mesh complete cylindrical plate (or half plate with symmetryPlane, running thru the center of drop, condition) for analysis to be correct?
Thanks in advance for help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Superlinear speedup in OpenFOAM 13||msrinath80||OpenFOAM Running, Solving & CFD||17||August 22, 2009 04:59|
|Modified OpenFOAM Forum Structure and New Mailing-List||pete||Site News & Announcements||0||June 29, 2009 06:56|
|64bitrhel5 OF installation instructions||mirko||OpenFOAM Installation||2||August 12, 2008 19:07|
|Adventure of fisrst openfoam installation on Ubuntu 710||jussi||OpenFOAM Installation||0||April 24, 2008 15:25|
|OpenFOAM Debian packaging current status problems and TODOs||oseen||OpenFOAM Installation||9||August 26, 2007 14:50|