setFields/mesh problem

anufagbemi · January 3, 2019, 22:06

Hi Foamers,
-I am running a 2-phase flow simulation using interFoam.
-I have about 3 million cells.
-I just ran setFields, and I have not run anything else absolutely.

=>But however, i manage to get an incompletely set secondary field at the outer boundary faces after viewing in paraview.
-I ran did exactly the same with a coarser mesh, and everything was good. However, as soon as I refined the mesh, i got this.

-My mesh quality seems good from the mesh stats attached.

=>Please what do you guys think could be the problem here.

Regards
anufagbemi

LuckyTran · January 7, 2019, 13:46

According to my understanding, setFields changes only the interior values in the internal fields and does not touch the boundaries at all. Can you quickly verify?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 05:59
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

January 7, 2019, 13:46		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,674 Rep Power: 66	According to my understanding, setFields changes only the interior values in the internal fields and does not touch the boundaries at all. Can you quickly verify?