|
[Sponsors] |
August 30, 2002, 09:12 |
Transient Simulation
|
#1 |
Guest
Posts: n/a
|
Hello!
I am simulating a heat source that has a variable heat release rate. For the first 3 seconds it is constant at one value and for the remaining portion of the simulation it has a lower heat release. All of the time steps in the first 3 seconds converge without any problem, but after the heat release rate changes, the temperature "sticks" at the previous temperature. The TEM1 %Error stays constant, no matter what relaxation settings I apply. Does anyone have any hints, please? Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient simulation | Pramila | Main CFD Forum | 2 | October 1, 2010 04:01 |
Transient Simulation | Cathy Lee | FLUENT | 10 | September 29, 2010 21:49 |
Transient simulation | astro1 | FLUENT | 0 | October 22, 2006 10:28 |
Anyone use RSM in transient simulation? | Pete | Main CFD Forum | 0 | March 13, 2005 03:29 |
is this a transient simulation? | Joana | Main CFD Forum | 7 | March 11, 2005 14:41 |