|September 23, 2010, 04:36||
Need help about Flow simulation by using PHOENICS!
Join Date: Mar 2009
Location: Tokyo, Japan
Posts: 100Rep Power: 7
hey all, I am trying to run a simulation of flow induced by plasma actuator using PHOENICS. But I don't understand how to set electrical conductivity.
please check these two link: how to set electric permittivity in plasma actuator induce flow simulation.
How to make simulation of body force in plasma actuator induce flow?
|phoenics, plasma actuator, simulation|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Plasma Flow Modelling using Source term and cell's data||Constantine||Fluent UDF and Scheme Programming||2||May 19, 2010 21:06|
|calculate volume flow from a 2D simulation||SimonH.||OpenFOAM||0||October 27, 2009 05:39|
|Simulation of Flow induced vibration on an elastically mounted bluff body in a cross||pradeepta||FLUENT||2||September 17, 2009 07:18|
|Expert parameter to stop the fluid flow simulation||KK||CFX||1||February 25, 2008 16:29|
|simulation of non-newtonian flow||mqits||FLUENT||2||August 14, 2007 11:24|