Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Boris_M

Forum: FloEFD, FloWorks & FloTHERM

January 25, 2012, 02:53

Replies: 6

Surface dissapears after moving!

Views: 2,235

Posted By Boris_M

No, of course the unit change alone does not...

No, of course the unit change alone does not change the limit.
For assemblies it can be that the limit is per single part and the assembly doesn't care about that or has a higher limit then. Haven't...

Forum: FloEFD, FloWorks & FloTHERM

January 18, 2012, 08:53

Replies: 6

Surface dissapears after moving!

Views: 2,235

Posted By Boris_M

To change the models units you have to go into...

To change the models units you have to go into the "options" under "tools" in menu and if you go then into the second tab "document properties" you'll find a point units. But for general scaling it...

Forum: FloEFD, FloWorks & FloTHERM

January 18, 2012, 08:13

Replies: 6

Surface dissapears after moving!

Views: 2,235

Posted By Boris_M

Yup, just checked with a colleague who knows SW a...

Yup, just checked with a colleague who knows SW a little better than I do and in SW 1km is the dimension limit which you seemed to have reached. This limit is from origin 500m in each direction.
...

Forum: FloEFD, FloWorks & FloTHERM

January 18, 2012, 08:01

Replies: 6

Surface dissapears after moving!

Views: 2,235

Posted By Boris_M

I believ that's a limitation of SolidWorks. If...

I believ that's a limitation of SolidWorks. If you use the function "Move/Copy..." you experience something similar. The face will not move over a certain value. Here you get a message that the value...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 02:32.