|
[Sponsors] |
November 13, 2012, 22:43 |
matching pressure drop with test set up
|
#1 |
Member
adam
Join Date: Oct 2011
Posts: 52
Rep Power: 14 |
I'm running a simulation that has a lower pressure drop than what I'm reading from a similar experimental test set up. In the test set up, there is a fan at the inlet whereas in the simulation the inlet is just velocity with uniform flow. I'm guessing the higher losses in the experiment are due to fan swirl, because all the dimensions between the two are exact. How do I account for the extra DP in the experimental set up caused by the fan? I have tried messing with the turbulence intensity and other settings but that had zero influence.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] ICEM Scripting Issues | tylerplowright | ANSYS Meshing & Geometry | 33 | September 27, 2021 16:35 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
pressure drop | jay | Main CFD Forum | 1 | September 24, 2008 09:27 |
How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 10:15 |
Hydrostatic pressure in 2-phase flow modeling (CFX4.2) | HB &DS | CFX | 0 | January 9, 2000 13:19 |