|October 10, 2013, 20:33||
Setup processing servers
Join Date: Oct 2013
Posts: 1Rep Power: 0
If I'm reading the documentation correctly, StarCCM can send processing jobs to servers, am I correct? I tried to follow this guide, but I don't understand enough of it to start the CCM processing server.
Can someone advise on how to run said server?
We're looking to add servers to assist in running a 64-bit mesh processing job from a 32-bit client.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] surface/curve mesh setup||Studi||ANSYS Meshing & Geometry||15||November 12, 2014 01:32|
|[ICEM] Hexa mesh, curve mesh setup, bunching law||Anorky||ANSYS Meshing & Geometry||4||November 12, 2014 01:27|
|Server Of Servers Setup||stuart23||EnSight||1||December 19, 2012 14:37|
|NO model vs post processing in coal combustion,CFX||sakalido||CFX||1||April 15, 2011 14:07|
|Post Processing in FEM||Abhijit Tilak||Main CFD Forum||0||April 26, 2004 11:59|