|
[Sponsors] |
February 12, 2010, 06:29 |
Baffle meshing problem with polyedral mesher
|
#1 |
New Member
Felix
Join Date: Aug 2009
Posts: 3
Rep Power: 16 |
Hello!
I'm having this problem: having a baffle floating in the same continua i define it as an interface and then go trough the volume mesh when i initialise the run it tells me that the baffle interface is invalid because all the cells spans both sides of the interface. This happens only with the polyedral mesh (no problems found with a tethraedral volume mesh) can someone help me? I cannot run it on tethraedral as the cell count is 5 times more. TNX Fex |
|
Tags |
baffle, cell, interface, polyhedral mesh, sides, span |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing problem | Sanjay Jain | FLUENT | 6 | April 5, 2008 09:51 |
Problem meshing very thin pipe | B. Hemmen | FLUENT | 2 | May 16, 2006 08:29 |
3D-gambit meshing problem | prem | FLUENT | 3 | February 28, 2006 02:42 |
Baffle cell problem in shock tube | AB | Siemens | 4 | November 15, 2004 08:44 |
GAMBIT meshing problem | Gauthier Lambert | Main CFD Forum | 1 | August 3, 2000 09:22 |