|October 15, 2012, 14:17||
STAR-CD tutorial 16(LES of turbulent channel flow)
Join Date: Feb 2012
Location: State College, PA
Posts: 3Rep Power: 5
I am trying to do tutorial 16.2(LES of turbulent channel flow). I am able to run the code successfully. But, while post processing I am using my stand alone code to average the velocity over each slice in y-direction by processing the exported tecplot data file. I am observing a 10% error in the results.
But, when I run the MACRO script given in the tutorial I get the correct results.
I tried to check the MACRO script and observed that while averaging the LES data the velocity is added for a cell set of 1350 for each y-slice and is being divided by (30x50=1500). I think this is where the 10% error is vanishing.
Did anybody had a similar problem? Does anybody know the reason behind it?
I even checked the velocity at the midplane which is over 21 m/s but in the plot from star-cd the maximum goes to about 19 only.
|Thread||Thread Starter||Forum||Replies||Last Post|
|LES In Turbulent in channel flow||pankaj saha||Main CFD Forum||18||November 20, 2014 06:49|
|Using starToFoam||clo||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||33||September 26, 2012 04:04|
|references for how to maintain a constant flow rate in turbulent channel flow||amirrstg||Main CFD Forum||0||October 25, 2011 03:17|
|Natural convection - Inlet boundary condition||max91||CFX||1||July 29, 2008 20:28|
|Reynolds and Turbulent flow||Frederic Dubinski||CFX||5||October 21, 2004 04:12|