|
[Sponsors] |
May 18, 2009, 12:07 |
Star-CD 4 and importing mesh
|
#1 |
Member
Hamoudi djamel
Join Date: Apr 2009
Posts: 50
Rep Power: 17 |
please it is very Urgent
I build my 2D geometry in ICEM-CFD and after this I export the 2D Mesh of this Geometry to solve it in Star-CD 4 but i receive a message that the Star-cd 4 do not accept the 2D mesh importing i try to use the solver of Star-CD 3.1.0 et Star CD 3.0.5 it was good but there is an other problem that the Star-CD 4 can not read the old boundaries then i have 0 boundaries then i can not define my boundaries in Star-CD4 please if any one have a solution please i am in a waiting thanck you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error when importing cgns mesh created with numeca | Pe2 | CFX | 1 | May 14, 2009 18:30 |
Importing a mesh from ICEM | Waseem Siddique | Siemens | 14 | February 9, 2009 05:05 |
Importing mesh problem | ParodDav | CFX | 1 | May 14, 2007 18:15 |
Problem in importing the Mesh | fred | Siemens | 4 | May 13, 2005 12:36 |
Error on importing mesh into Pre | Louwrens | CFX | 0 | October 7, 2003 11:55 |