|
[Sponsors] |
Meshing of a sharp edge orifice with a radius |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 2, 2011, 13:11 |
Meshing of a sharp edge orifice with a radius
|
#1 |
New Member
Join Date: Dec 2011
Posts: 4
Rep Power: 14 |
Hi, I am trying to mesh a sharp edge orifice that has a radius between the 2 cylinders.
http://imageshack.us/photo/my-images...dgeradius.gif/ Here is a zoom of the sharp edge. I made the radius by moving some vertices to create a radius, but I am concerned about the non-smooth transition between the angles of my cells. Do you guys have any ideas how could I have a better mesh around the radius. I want to keep the rest of my mesh as quad cells. Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] Hole near sharp trailing edge of airplane/wing geometry | jlichtwa | ANSYS Meshing & Geometry | 2 | September 21, 2010 15:19 |
Which trailing edge is correct for meshing of aerofoils for CFX | LSC | CFX | 0 | May 10, 2009 12:45 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
meshing a sharp edge | line | CFX | 2 | November 2, 2002 11:19 |