|
[Sponsors] |
May 16, 2012, 00:36 |
Boundary Wrap - Issue
|
#1 |
Senior Member
Ali
Join Date: Jan 2012
Location: Pakistan
Posts: 134
Rep Power: 16 |
I am trying to make a mesh using TGrid because my geometry is too dirty (impossible to clean and reproducing it takes too long).
TGrid helps me too much but I am facing some issue at surface junctions (figure attached). My geometry is wing-body type. The problem arises at the wing tails junctions. The mesh is not smooth, boundary is not captured according to the geometry. I am in a hurry to make its mesh. Any prompt suggestion is highly appreciated.
__________________
Best Regards Ali |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
Pressure boundary condition issue | Vijay | FLUENT | 0 | April 6, 2012 13:35 |
[Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 10:56 |
Solver error message!!! | IoSa | CFX | 1 | September 14, 2006 04:48 |
Fluent 5.0 boundary condition issue with RSM | Flav | Main CFD Forum | 2 | October 20, 1999 04:57 |