[ANSYS Meshing] Why doesn't ANSYS Meshing allow me to make a very fine mesh? -- CFD Online Discussion Forums

May 21, 2012, 11:04

Why doesn't ANSYS Meshing allow me to make a very fine mesh?

ali.qasim

New Member

Ali

Join Date: Apr 2012

Location: India

Posts: 17

Rep Power: 14

I'm trying to make a C-mesh over an airfoil.

The first image shows my original mesh. But when I try to increase the bias factor or the number of divisions, so as to improve the resolution near the airfoil, I get the second image.

Any idea why this is happening?

Attached Images

	1.jpg (60.8 KB, 62 views)
	2.jpg (69.4 KB, 54 views)

James Hetfield likes this.

Last edited by ali.qasim; May 21, 2012 at 11:07. Reason: attached images

Tags

bias factor, fine, mesh

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit problems	Althea	FLUENT	22	January 4, 2017 03:19
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3	flakid	OpenFOAM Installation	16	December 28, 2010 08:48
ANSYS Meshing - DC Mesh Quality	alven299	ANSYS Meshing & Geometry	5	July 19, 2010 11:34
[Commercial meshers] How to make a good Low-Re Mesh ?	Gearb0x	OpenFOAM Meshing & Mesh Conversion	0	February 12, 2010 04:48
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 14:09

All times are GMT -4. The time now is 11:49.