|July 22, 2012, 02:54||
Remotely running ICEM with NoMachine NX
Join Date: Jan 2012
Posts: 19Rep Power: 5
i am trying to remotely working with ICEM via NoMachine NX but, every time i open a NoMachine session trying to run ICEM, the ICEM process failed.
Someone says this could be caused by the native graphic environment of ICEM.
This is the error i receive from the terminal.
Signal 11 caught!
segmentation violation - exiting after doing an emergency save
X Error of failed request: BadLength (poly request too large or internal Xlib length error)
Major opcode of failed request: 65 (X_PolyLine)
Serial number of failed request: 4477
Current serial number in output stream: 4478
Anyone can help me for resolving this problem?
Thanks in advance!:
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] periodic tolerance icem tetra / hexa||Jonathan||ANSYS Meshing & Geometry||4||December 22, 2011 12:26|
|icem script||prad||CFX||5||July 23, 2010 16:30|
|ICEM hexa mesh built with v10 deformed in v11 (degenerated edges)||cfxicem||ANSYS Meshing & Geometry||1||October 14, 2009 15:06|
|Statically Compiling OpenFOAM Issues||herzfeldd||OpenFOAM Installation||21||January 6, 2009 10:38|
|Kubuntu uses dash breaks All scripts in tutorials||platopus||OpenFOAM Bugs||8||April 15, 2008 07:52|