[ANSYS Meshing] Meshing Geometry -- CFD Online Discussion Forums

September 17, 2012, 13:13

Meshing Geometry

Danath

Member

Evangelos

Join Date: Sep 2011

Posts: 87

Rep Power: 14

Hello!

i want to mesh the geometry in the picture parallel .

I want to make boundary layer as dense as i can and the center of each volume thin.

how can i do that ?

i try to size every edge on my geometry but the results was not so good because there was skewness parallel 2

Attached Images

	parallel.jpg (45.0 KB, 49 views)
	parallel 2.jpg (59.3 KB, 39 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Meshing an irregular geometry	Fabio Tabacow	ANSYS Meshing & Geometry	6	May 7, 2014 16:03
[ICEM] Geometry Meshing	protea	ANSYS Meshing & Geometry	2	November 22, 2011 12:15
[ANSYS Meshing] Using more than one meshing method on a single 2D geometry	robbierich90	ANSYS Meshing & Geometry	0	October 30, 2011 13:12
Need help on meshing this simple geometry	nha1g08	ANSYS Meshing & Geometry	3	March 9, 2011 02:13
meshing geometry in gambit	soundar	FLUENT	1	January 7, 2005 02:59

All times are GMT -4. The time now is 11:26.