|February 19, 2013, 06:47||
combination GAMBIT and ICEM
Join Date: Jul 2009
Posts: 13Rep Power: 7
Hello Far and all,
you have said:
"7. You can use combination of different meshers. For example recently one of my freind used the Gambit and ICEM. They used Gambit for geometry cleaning (also reproduces some dirty parts) and tetra volume mesh. This mesh was saved in .msh format and imported into ICEM. Where with build topoogy underlying goemtry was reproduced and then prism mesh was extruded from the tetra mesh near to wall surface."
According to your suggestion, i have saved *.msh in GAMBIT and imported in ICEM. My question is how i can build topology underlying geometry? After importing in ICEM the geometry is not available.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Gambit to ICEM, any advices ?||Santos-Dumont||ANSYS Meshing & Geometry||16||February 28, 2012 20:07|
|[ICEM] Gambit to Openfoam, Gambit to ICEM to Openfoam||Rickard.Solsjo||ANSYS Meshing & Geometry||7||November 30, 2011 11:20|
|[ICEM] Export ICEM mesh to Gambit / Fluent||romekr||ANSYS Meshing & Geometry||1||November 26, 2011 13:11|
|Help: mesh conversion from Gambit to ICEM||sarah_ron2002||FLUENT||2||April 5, 2008 01:53|
|How to export gambit model to ICEM||Nirupama||Main CFD Forum||1||October 28, 2006 13:06|