[Marion]

Hi everyone,

I am a Gambit / Fluent user, and I use Workbench with Design Modeler and Ansys Meshing from time to time for specific projects, especially when the mesh is not too complex (with large, complex meshes I've never been satisfied by the mesh in Ansys Meshing).

This time I am carrying out an FSI simulation, on a simple case. And even with this I find it so time consuming. A simple operation like selecting faces for my named selections is very frustrating:
1. click on the face
2. right click - named selection
3. in the Named Selection panel, click "apply" so that the face is actually selected + write a name
4. click on "generate"

and then do that again for... 18 faces.

Therefore I was wondering: is there a way to avoid clicking on "generate" for each named selection?

I really dont see the point of losing time over something like that. But I am not an expert in Ansys Design Modeler, so there may be a quicker way.

Thank you,

Marion.