|July 3, 2013, 06:46||
First layer height decrease
Join Date: May 2013
Posts: 1Rep Power: 0
I am running a Fluent simulation of a 2D model of a car in a wind tunnel, using k-epsilon method.
I'd like to have all my y+ along the top side of the car the nearest to 30 to have the better precision. The "problem" is that the velocity is increasing along the windshield (flow section decreasing), the same for the y+ values.
My question is : is there a way to decrease the size/height of the boundary cells elements from the bottom to the top of the windshield ? (to remain the y+ at value)
Thank's in advance
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] First layer height - units||saisanthoshm88||ANSYS Meshing & Geometry||1||May 16, 2012 15:16|
|Boundary layer in a pipe||Clementhuon||OpenFOAM Native Meshers: snappyHexMesh and Others||6||March 12, 2012 14:41|
|Boundary layer generation problems||ivan_cozza||OpenFOAM Native Meshers: snappyHexMesh and Others||0||October 6, 2010 14:47|
|Height of boundary layer||DAK565656||CFX||2||April 19, 2007 12:30|
|errors||Fahad||Main CFD Forum||0||March 23, 2004 14:20|