|March 30, 2014, 21:11||
Need help in Meshing!
Lou Wei Jie
Join Date: Mar 2014
Posts: 1Rep Power: 0
Hi, i'm new here and i'm beginner in learning Ansys software. i was trying to run simulation on NACA 8612 airfoil. everything was good in geometry until it came to meshing.
apparently one of my quadrant is messed up when i have no idea why.
can anyone kind enough to give me some advice on this?
kind of urgent as i'm doing it for my final year project in building a vertical axis wind turbine.
i attached the image of my meshing here too.
|March 31, 2014, 11:18||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
I guess you followed the tutorial available in Cornell's website. A lot of people face this kind of issue, use the search button of the forum, you will find a solution for it, it has been discussed before... many times
New to ICEM CFD, try this document --> http://goo.gl/G2gkE
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ANSYS Meshing] Can I use ANSYS Meshing for manual meshing?||Kirjain||ANSYS Meshing & Geometry||6||November 30, 2015 09:11|
|Best Meshing scheme for Cylinder||Nutrex||Main CFD Forum||4||July 29, 2008 11:03|
|Meshing locks workbench window.||andy2o||CFX||0||February 1, 2008 06:01|
|Singularity of grid?Volume meshing vs face meshing||Ken||Main CFD Forum||0||September 4, 2003 11:09|
|Volume Meshing & Face Meshing? singularity of grid||ken||FLUENT||0||September 4, 2003 11:08|