|January 15, 2015, 12:05||
ICEM CFD´s return status was 7.
Join Date: Mar 2009
Location: Berlin, Germany
Posts: 446Rep Power: 12
when running a design point study in wb2.0 i am not able to update my new design-points anymore.
Since i am doing FSI-simulations, i am changing the whole setup e.g. rotate about an axis and re-run the simulation. Which worked pretty well for a very long time but since my last dp ANSYS and CFX don´t share the same AoA (afai can see it from the errors arising), and therefore cannot map properly between CSM and CFD. I nailed the problem down to the ICEM meshing and found "ICEM CFD´s return status was 7." in the ICM-1.txt within the ICEM folder of the mentioned dp.
Funny thing is... the mesh in the folder is correct, and everything looks fine regarding the meshes and the positions/interfaces... it seems like ICEM is telling the wb2.0 smth. wrong which causes the process to stop and use an old mesh, which in turn causes the interface to be wrong (unmapped nodes) etc....
Anybody familiar with the "status 7"?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Creating a new field from terms of the turbulence model||HaZe||OpenFOAM Programming & Development||15||November 24, 2014 14:51|
|OpenFOAM 1.6 ext||fportela||OpenFOAM Installation||11||December 26, 2013 19:55|
|[ICEM] Different meshes from ICEM and GAMBIT||Mojtaba.a||ANSYS Meshing & Geometry||9||March 30, 2013 03:42|
|cfx5post in batch mode on "graphics-less" Linux||frankyd||CFX||3||April 12, 2011 16:47|
|Missing math.h header||Travis||FLUENT||4||January 15, 2009 12:48|