|
[Sponsors] |
May 13, 2015, 09:38 |
One block face not meshed
|
#1 |
Member
Join Date: Dec 2012
Posts: 81
Rep Power: 13 |
Hi there,
I have a question regarding my meshing attempt. I managed to mesh my wing but for some reason one block face (see attached picture) doesnt want to mesh. It is on the inlet (picture1) but on the outlet (picture2) the mesh is fine again. I dont really know what causes this problem as I have already checked the edge parameters. Can anyone help me, please? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 14:18 |
[snappyHexMesh] How to define to right point for locationInMesh | Mirage12 | OpenFOAM Meshing & Mesh Conversion | 7 | March 13, 2016 14:07 |
Error message: 8 face(s) not in face lists of adjacent cells | jyoung79 | FLUENT | 0 | November 10, 2012 16:09 |
Hydrostatic Pressure and Gravity | miliante | OpenFOAM Running, Solving & CFD | 132 | October 7, 2012 22:50 |
[GAMBIT] Unable to create .msh file due high order elements on meshed face error | Ty@flent | ANSYS Meshing & Geometry | 2 | August 29, 2011 16:05 |