|August 28, 2011, 05:17||
Join Date: Sep 2010
Posts: 44Rep Power: 9
I am doing blocking for a part and my doubt is something similar to the example shown here.
If we have a sudden enlarged pipe like this we have to split the block to capture the bigger diameter and the smaller diameter and if we created a O-grid to get a good mesh, then at the enlarged section the quality of mesh is very poor.
If we create 3 or 4 O- grids inside to capture the features inside a cylindrical part then it will becomes much complicated and the quality is even worst.
Kindly any one help me how to solve this problem.
Thanks in advance.
|August 30, 2011, 11:00||
Join Date: Sep 2009
Posts: 323Rep Power: 14
- Create a first O-grid for your global geometry
- Cut it at the jonction of your 2 tubes.
- Create another O-grid for your global geometry inside the first one to capture the small tube.
- Delete the blocks around your small tube.
You can do another o-grid inside the small tube to increase the quality
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] o grid blocking strategy?||icemaniac178||ANSYS Meshing & Geometry||14||March 20, 2013 00:18|
|[ICEM] Blocking and Symmetry||BrolY||ANSYS Meshing & Geometry||32||August 24, 2012 03:13|
|[ICEM] Blocking of 2 cylinders||FrankW||ANSYS Meshing & Geometry||5||April 14, 2011 10:49|
|[ICEM] Blocking strategy||BrolY||ANSYS Meshing & Geometry||0||July 22, 2010 04:46|
|Mesh is created in blocking||Severin||CFX||3||September 18, 2007 09:02|