|
[Sponsors] |
September 17, 2007, 12:49 |
Mesh is created in blocking
|
#1 |
Guest
Posts: n/a
|
Hi!
I'm an Icem Newby. I have a simple question. I try to create a Mesh in my geometry. But the mesh always appears in the blocking I created. This is what I did: 1. I created my geommetry 2. create block ==> initalize block 3. association of edge to curve 4. move vertex ==> move vertex 5. setting the pre mesh parms 6. toggeling pre mesh view on and then i see, that the mesh is in my blocking but not into my geometry. Is this a frequent problem? Does anybody know where/what i did wrong? I reapeted the steps again and again, but I always got the same results (mesh in the blocking)... Do you need further information? Maybe a screenshot? Thanks for helping!!! |
|
September 17, 2007, 15:14 |
Re: Mesh is created in blocking
|
#2 |
Guest
Posts: n/a
|
I noticed this myself, although I have not used ICEM for Hex meshing for some time. Suggestion: (The following may not be the "correct" way, but it seemed to work for me)... To see the mesh, activate your block volume and the "premesh" toggle. You should then see the surface mesh when selected. To write out the mesh, try right clicking on the "premesh" label and saving the mesh as strustured or unstructured. You can then write out the mesh by selecting the format desired and write as usual.
|
|
September 18, 2007, 03:21 |
Re: Mesh is created in blocking
|
#3 |
Guest
Posts: n/a
|
right click on the premesh and select project faces. If the option is no projection you will get meshes on the blocks.
Regards, Bala |
|
September 18, 2007, 10:02 |
Re: Mesh is created in blocking
|
#4 |
Guest
Posts: n/a
|
Thank you very much for your help!!
Now everything runs well. sincerly Severin |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 07:41 |
[ICEM] Is it possible to blocking and mesh part of geometry? | zhaohui | ANSYS Meshing & Geometry | 5 | March 25, 2016 06:12 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
How To save a created mesh file in Ansys Meshing | ashtonJ | CFX | 4 | January 7, 2012 23:04 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |