|
[Sponsors] |
February 20, 2012, 12:53 |
Question about Formatted Point Data
|
#1 |
Member
Brian Henry
Join Date: Aug 2010
Posts: 42
Rep Power: 15 |
Hello, all, thanks for reading this,
I was making a binary tree structure, and I managed to write a MATLAB writer that brings the tree into ICEM CFD via the formatted point data input, but I have a question. Is it possible to build cylinders through this input as well? Basically, I have it so it continually writes curves for two points (but no surfaces because I don't need b-splining for a binary tree). In other words, I can build the 2-D trees, but I also want to build 3-D cylinders on the 2 points as well. Is this possible? Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to put melting Point data of inert particle in DPM model | subhankar_bhandari | Main CFD Forum | 0 | July 26, 2010 07:28 |
How to get the data of second cell or point near the wall? | jelon | STAR-CCM+ | 0 | April 24, 2010 02:04 |
extract point data | susan | Siemens | 4 | November 27, 2007 14:04 |
Monitoring data at a point within CFD domain. | James | Siemens | 1 | April 17, 2007 15:02 |
radial turbine data export question | ally | CFX | 0 | September 14, 2005 15:10 |