|November 26, 2012, 04:23||
2D pressure flotran to usable force
Join Date: Nov 2012
Posts: 1Rep Power: 0
I'm just new with the flotran options in ansys and new with fluid dynamics. For a project i must calculate the drag and lift coefficient of a profile in ansys flotran.
I made an 2D profile in ansys and solved it but i only can get the pressure on every node out of the solver. So it's a pressure without an area ? So now i must calculate the force for C=F/(rho*dens*V^2*A)
I found a paper on google about this:
But in Figure 3B there's an formula FF=(Pi+Pi-1)/(2*abs(Yi-Yi-1)) that gives not the results that are mentioned in table.
Can anyone explain me how this is calculated ?
Because when i do this i don't have the same results as in the table.
Or is there an other way to do this ?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pressure force calculation in incompressible solvers||philippose||OpenFOAM Running, Solving & CFD||8||August 26, 2015 10:57|
|FSI: Pressure and Normal Force don't match with expected values||Geraud||CFX||6||August 21, 2012 15:34|
|Setup/monitor points of pressure and force coefficients||siw||CFX||3||October 22, 2010 06:07|
|Ansys Flotran: Velocity or Pressure BC?||eu-ric thean||CFX||2||December 28, 2005 13:06|
|Calculate Pressure force||andreis||FLUENT||0||May 16, 2005 05:40|