Home > Forums > CD-adapco

Error in moving mesh

Mark Forums Read

Reply

January 10, 2005, 06:44	Error in moving mesh	#1
sasikumar Guest Posts: n/a	Dear sir, I am doing my P.G in Anna univ.and doing my project in CFD-star CD.Regarding my project i want to do moving mesh,so that i gave bowl vertex points then connected everything with spline and patch that surface finally revalved with 60 deg. and merged,compressed,but i got cell collapsed,crack and negative volume errors,how can rectifing that. regards, p.sasikumar, Anna university chennai tamilnadu.

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
a error for moving mesh	RX	CD-adapco	1	December 7, 2006 12:29
Error in moving mesh	Somnath	CD-adapco	2	January 20, 2005 10:49
Error while doing moving mesh	Harendra	CD-adapco	2	January 10, 2005 06:34
moving mesh error.	dorain	CD-adapco	0	December 7, 2004 00:50
moving mesh error	leo	CD-adapco	1	September 12, 2002 20:56

All times are GMT -4. The time now is 08:41.