|
[Sponsors] |
February 10, 2003, 10:49 |
Inflation parameters
|
#1 |
Guest
Posts: n/a
|
I have set an inflation boundary for my geometry, but when I set the inflation parameters and try to write the definition file I get this error message :-
Volume mesh warning: The surface mesh overlaps itself Does anybody have any ideas? Thanks Adrian |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Total Thickness of Inflation Layer | prikeyma | CFX | 5 | August 28, 2020 03:22 |
units of geometrical parameters lost | SoobY | ANSYS Meshing & Geometry | 2 | January 10, 2011 03:58 |
Large Valve Flow Analysis - Inflation Problem | sercan85 | ANSYS Meshing & Geometry | 2 | June 1, 2010 14:02 |
Inflation Parameters Suggestions | Scott | CFX | 1 | August 20, 2008 21:12 |
Inflation | Gab | CFX | 6 | August 24, 2005 22:45 |