Error msg: In Analysis 'Flow Analysis1 : No domains have been defined

m5edr · February 4, 2012, 23:14

I am try two suggested method
1- Define firstly a Domain and comeback to Cfx setup --->the same massage appears again

2-also Iam try to import my mesh externally but another error massage appear

Please help

jdt · February 5, 2012, 06:59

Could you please tell us some more information about your approach? For example, did you use ANSYS Meshing to mesh your geometry?

m5edr · February 5, 2012, 08:01

Quote:

Originally Posted by jdt

Could you please tell us some more information about your approach? For example, did you use ANSYS Meshing to mesh your geometry?

I am built my geometry (wind Turbine blade) in DesignModeler(Ansys12) then meshed it in Ansys12 meshing then I sholud open Cfx setup to set the B.c and I.c but didn't find the geometry (Error appear here)

jdt · February 5, 2012, 13:52

Is your geometry 2D or 3D?

What icon is shown next to the mesher box in Workbench? Is it a green tick?

m5edr · February 20, 2012, 08:17

I discovered that i should work with Ansys fluent not CFX , thanks any way

February 4, 2012, 23:14	Error msg: In Analysis 'Flow Analysis1 : No domains have been defined	#1
m5edr Senior Member mohamed khedr emam Join Date: Oct 2011 Location: Egypt Posts: 121 Rep Power: 14	I am try two suggested method 1- Define firstly a Domain and comeback to Cfx setup --->the same massage appears again 2-also Iam try to import my mesh externally but another error massage appear Please help

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFOAM static build on Cray XT5	asaijo	OpenFOAM Installation	9	April 6, 2011 12:21
Compressible flow analysis	Sonu	Siemens	3	December 5, 2007 07:25
User defined function of mass flow rate	Eric	FLUENT	1	April 22, 2005 18:15
Coolant flow analysis - IC engine	Frank	FLUENT	2	May 19, 2002 15:59
Flow visualization vs. Calculated flow patterns	Francisco Saldarriaga	Main CFD Forum	1	August 2, 1999 23:18

February 5, 2012, 06:59		#2
jdt New Member Join Date: Oct 2010 Posts: 4 Rep Power: 15	Could you please tell us some more information about your approach? For example, did you use ANSYS Meshing to mesh your geometry?

February 5, 2012, 13:52		#4
jdt New Member Join Date: Oct 2010 Posts: 4 Rep Power: 15	Is your geometry 2D or 3D? What icon is shown next to the mesher box in Workbench? Is it a green tick?

February 20, 2012, 08:17		#5
m5edr Senior Member mohamed khedr emam Join Date: Oct 2011 Location: Egypt Posts: 121 Rep Power: 14	I discovered that i should work with Ansys fluent not CFX , thanks any way