Vessel tutorial problem

hosseinhgf · March 3, 2012, 05:38

Hello
i have problem with "Multiphase Flow in a Mixing Vessel" tutorial.
When you running "MultiphaseMixer.pre" withSession>Play Tutorial you have a subregion in"MixerImpellerMesh.gtm" mesh that contain the 3d blade. But just three faces from ten faces of this 3d blade defined (two as interface and one as shaft) and other faces not defined. What happened for other faces?

When I setting up this tutorial manually (I did step by step that help said) the other faces appear in “impeller default” (I turned off Automatic Default Domain and Automatic Default Interfaces) that not exist in automatically set up. Why?

How create model with design modeler that there is face in domain (not thin surface) like blade and baffle in this tutorial without crating subdomain?

Thanks’ for reading

NimaMcGill · March 17, 2013, 11:39

Hi,

have you find the answer to your question?
I just started using ANSYS and I faced the same question.

March 3, 2012, 05:38	Vessel tutorial problem	#1
hosseinhgf Member h-h Join Date: Sep 2009 Posts: 38 Rep Power: 16	Hello i have problem with "Multiphase Flow in a Mixing Vessel" tutorial. When you running "MultiphaseMixer.pre" withSession>Play Tutorial you have a subregion in"MixerImpellerMesh.gtm" mesh that contain the 3d blade. But just three faces from ten faces of this 3d blade defined (two as interface and one as shaft) and other faces not defined. What happened for other faces? When I setting up this tutorial manually (I did step by step that help said) the other faces appear in “impeller default” (I turned off Automatic Default Domain and Automatic Default Interfaces) that not exist in automatically set up. Why? How create model with design modeler that there is face in domain (not thin surface) like blade and baffle in this tutorial without crating subdomain? Thanks’ for reading

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem on Fluent Tutorial: Horizontal Film Boilig	Feng	FLUENT	2	April 13, 2013 05:34
Boundary Condition For Pressure vessel Problem	abhayachougule	Main CFD Forum	2	October 26, 2010 07:48
Problem running cavityGrade Tutorial	CFDMike	OpenFOAM Running, Solving & CFD	0	September 23, 2010 07:46
Problem with icoDyMFoam tutorial	matlie	OpenFOAM Bugs	10	April 26, 2007 04:51
Rotating Vessel: Problem Set-Up	Harmeet	FLUENT	0	February 4, 2005 05:41

March 17, 2013, 11:39		#2
NimaMcGill New Member Nima Join Date: Mar 2013 Posts: 1 Rep Power: 0	Hi, have you find the answer to your question? I just started using ANSYS and I faced the same question.